Alex Zellner

The problem is the a gcode_macro variable can be anything from a simple bool or number to an complex dictionary structure. It would be imposable to build them all without...

Personally I do not believe in this kind of convention as most user will never find out about it. The right way would be to add a definition for e.g...

@airato that is part of V2.1 anyhow and can be done with any beta today

Solution Idea provided by discord user gdachs "maybe that: https://unix.stackexchange.com/questions/535269/how-can-i-have-one-systemd-service-trigger-another-after-it-completes"

OK, the gcode itself looks ok. Your console outputs shows that klipper itself has problems reading the gcode. For me that looks like a general klipper issue. Do you use...

Sorry for my late response, I still try to reproduce it. Can you tell use what PI you are using and how much ram it has?

Thanks, ok I have a PI zero 2W here that I can place in my Voron V2. The V2 normally use a PI4 and with that setup I could not...

Sorry, I needed some time to get all setuped. I tried it now on a delta using a pi zero 2W. And run never in the Problem you reported. I...

There where a fix in klipper https://github.com/Klipper3d/klipper/commit/f4440267e63dd372265fb223dc428ae3a83bf314 that might be eliminate your problem. I tried it before and after the fix and never seen it. Imwill close it for now...

Can not been reproduced. Even the opener does not see it any more after new HW and a fresh install.