Scott Lahteine

One interesting development in the area of thermal protection is Prusa Firmware updating its behavior so that if the temperature goes too far outside the hysteresis range for too long,...

I added a method called `center_z_base_offset` which is called after `G29` is done to automatically try to minimize the amount of Z leveling adjustment during motion / printing. In relation...

> Universal Z height setting Workspace offsets are applied with `G92` and this is the most straightforward offset. The `M206` offset is applied relative to the home position, and it...

If it is possible to apply the improvements outlined in this PR to the latest Marlin code, then please update this PR. If the changes are no longer compatible or...

Closing, as the last-known state has already been merged.

Does this represent an improvement in its current state, or does it need more fixing? I can merge the current state into `bugfix-2.1.x` for wider testing if it's reasonably functional....

Finally getting to a review of this submission…. It's an interesting diagnostic addition. Of course it should be pretty obvious to the user that homing failed merely by looking at...

> Should I go ahead and try to implement that auto tuning in this PR, or should it be a separate one? You can push it to this PR if...

It is best that the configuration with BLTouch match as closely as possible the parent config in all aspects that are not probe-related. If there are improvements to be made...

Is the bed temp sensor actually different on this model (1 instead of 5), with a higher max temp?