motion.arduino.ICM42670P

motion.arduino.ICM42670P copied to clipboard

initialization failed: -3

3

After connecting ICM42670P daughter board to it is now showing initialization failed: -3. Previously the result was observed correctly.

VaishakC7

IMU.begin() fails to starts

6

Using Adafruit Nordic nrf52 / nrf52832 Wire What is causing i2c to hang? Absence of NACK? ********************** Remote debugging using localhost:2331 0x00026830 in TwoWire::endTransmission (stopBit=true, this=0x20004870 ) at /home/pi/.platformio/packages/framework-arduinoadafruitnrf52/libraries/Wire/Wire_nRF52.cpp:230 230...

Lapporatory992

Fifo not triggering callback

2

Using the example "FIFO_interrupts" does not seems to ever trigger the callback function "event_cb". An interrupt occours and triggers `void irq_handler(void) { irq_received = 1; }` But using breakpoint, i...

kjs-eir

Failed IMU begin with error code -12

61

Hey, I have DK-42670-P development board. The spi pins are out on J4 for the development board. I have connected my esp32s3 spi pins there. But I am unable to...

SorabhR

Leftover FIFO samples after wake‑on‑motion with ICM42670P & ESP32

3

Hello everyone, I’m running into an issue with reading the FIFO on my ESP32 using the ICM42670P and the Arduino IDE. I need to perform a time‑critical measurement immediately after...

fcziborr

startWakeOnMotion only configures interrupt on INT1, but accepts intpin

3

The `ICM42670::startWakeOnMotion(uint8_t intpin, ICM42670_irq_handler handler)` seems hardcoded to only configure interrupts on **INT1**. Shouldn't it include if statement or similar so if `intpin == 2` it will configure **INT_SOURCE3** and...

kjs-eir