[BUG] esp32-s3 simplefoc adcRead bug

[MGJ520]

This is a current ADC channel configuration bug

This function

uint16_t IRAM_ATTR adcRead(uint8_t pin)

//修改7 change 7->9 if(channel > 9){ channel -= 10; CLEAR_PERI_REG_MASK(SENS_SAR_MEAS2_CTRL2_REG, SENS_MEAS2_START_SAR_M); SET_PERI_REG_BITS(SENS_SAR_MEAS2_CTRL2_REG, SENS_SAR2_EN_PAD, (1 << channel), SENS_SAR2_EN_PAD_S); SET_PERI_REG_MASK(SENS_SAR_MEAS2_CTRL2_REG, SENS_MEAS2_START_SAR_M); } else { CLEAR_PERI_REG_MASK(SENS_SAR_MEAS1_CTRL2_REG, SENS_MEAS1_START_SAR_M); SET_PERI_REG_BITS(SENS_SAR_MEAS1_CTRL2_REG, SENS_SAR1_EN_PAD, (1 << channel), SENS_SAR1_EN_PAD_S); SET_PERI_REG_MASK(SENS_SAR_MEAS1_CTRL2_REG, SENS_MEAS1_START_SAR_M); }

uint16_t value = 0;

//修改7 change 7->9
if(channel > 9){
    while (GET_PERI_REG_MASK(SENS_SAR_MEAS2_CTRL2_REG, SENS_MEAS2_DONE_SAR) == 0); //wait for conversion
    value = GET_PERI_REG_BITS2(SENS_SAR_MEAS2_CTRL2_REG, SENS_MEAS2_DATA_SAR, SENS_MEAS2_DATA_SAR_S);
} else {
    while (GET_PERI_REG_MASK(SENS_SAR_MEAS1_CTRL2_REG, SENS_MEAS1_DONE_SAR) == 0); //wait for conversion
    value = GET_PERI_REG_BITS2(SENS_SAR_MEAS1_CTRL2_REG, SENS_MEAS1_DATA_SAR, SENS_MEAS1_DATA_SAR_S);
}

================================

esp32-s3 io9 io10 ->adc use _readADCVoltageLowSide,

But channel is a mistake!!not work.

So i change 7->9,it work good.

because io9 io10 belong ... channel0