OpenModSim

OpenModSim copied to clipboard

working perfect in RS485  i am using a STM32WL55 using RS-485

tcpipchip

Selection of network card

3

I'm trying to configure the Modbus slave to be active on a specific NIC om my computer, but I'm not able to select which NIC the slave should connect to,...

Comiter

damaged Frames

1

Hello, I am using OpenModSim for the first time today. I have encountered the following problem: When I use OpenModSim 1.2.0 with a Loytec LINX-202 with ModBus/RTU (Slave 1, 19200,8N1),...

Xander0823

auto connect after start the program

1

how auto connect after start the program ?

edwina95

missing Address 42001 value 0x0008

1

 

Chadlucc

Modbus-RTU-4ch-Relay-12v

2

I have been trying to use this program with this card: https://mikroelectron.com/Product/Modbus-RTU-4ch-Relay-12v-RS485-Module-4-Input-Optocoupler-Isolation/ but it does not work. What could I be doing wrong or if it definitely doesn't work for...

cofhal

Нет ответа от устройства при значения "Бит скорости 7" или " Стоповый бит 2"

2

Если при условиях настройки, к примеру, 9600:8:N:1 у OmodSim и аналогичных OmodScan, я получаю сгенерированные данные. То при настройках 9600:7:N:1 или 9600:8:N:2 или 9600:7:N:2 у OmodSim, OmodScan оповещает "Нет ответа...

artyras

Unable to set different device id for different modsim instances.

3

Somehow, when changing the device id in ModSim2, it changes the device id in ModSim1 to the same Id. 

evo0705

PedroCobucci

Address values not saving correctly

3

When you create a new project, set some values, and then save and open it later. Boom! the values are gone

PedroCobucci