rpi-eeprom

rpi-eeprom copied to clipboard

Cannot boot from MXT USB2 uSD card reader

4

### Describe the bug This USB card reader works fine in Raspberry Pi OS, but it is not recognised by the USB boot loader. ### Steps to reproduce the behaviour...

procount

### Describe the bug The system boots. And, unless I am mistaken, the bootloader of the pi 5 (in its latest version, as of today ~`a482d84ba68bf5e0c150434d56061e6afa967b96`) does not set the...

gportay

Network install doesn't start with wireless keyboard/trackpad

5

### Describe the bug I've seen others having the same issue. It works as expected with a HP wired keyboard, never shows the red splash screen when I have Logitech...

jmhalder

[CM4] BCM-USB-MSD seems broken

3

### Describe the bug In order to be able to easily do updates to an embedded device in the field, I would like to use BCM-USB-MSD (0x5) before eMMC. Unfortunately...

dirkdimehead

### Describe the bug During the IPv6 network boot the bootloader does not respond to IPv6 "neighbor solicitation" (NS) packets. This blocks the boot process as dnsmasq (and radvd) needs...

middelkoopt

Raspberry Pi 5 PMIC does not negotiate 5A current via USB-PD PPS profile

15

### Describe the bug The raspberry Pi 5 PMIC does not make use of 5000 mA current offered by a charger via USB-PD PPS profile. Instead, it gets stuck at...

l3iggs

rpi-eeprom-update does not list latest VLI eeprom

4

### Describe the bug rpi-eeprom-update doesn't list the latest VL805 firmware update until after it has been installed. ``` root@pi-taucha:~# rpi-eeprom-update *** UPDATE AVAILABLE *** BOOTLOADER: update available CURRENT: Thu...

hailfinger

Pi 4 conditional configs seem parsed before halt and get confusing when booting later

4

### Describe the bug It seems that bootloader conditional configurations are evaluated and stored when entering halt mode. Later, when starting from halt mode it seems that the conditionals are...

jheeks

CM4 bootloader does not appear to read or honor EDID

12

### Describe the bug We have two CM4-based panel PCs. One driving a 7" touchscreen LCD, and the other driving a 10" touchscreen LCD. Both are identical with the exception...

JinShil

CM4 bootloader not booting from MSD GPT boot partition when GPIO is active

4

### Describe the bug Cannot boot into alternate boot partition. HDMI does not work when GPIO 6 is pull low on power up to load this boot partition. CM4 is...

knro