procount

Not yet. Feel free to experiment further with KMS overlays etc. The pinn_init script won't work on Pi5 yet since it still uses tvservice. I need to implement similar KMS...

It looks like you are installing to SD card, so PINN will use the /dev/mmcblk0pX notation. If installing to USB, then it would use PARTUUIDs. I can't remember if you...

Sorry, I have no time to look at the moment. But if MoOde is based on raspios or the latest kernel, then perhaps its partition_setup.sh script should be looking in...

I tried it but as mentioned on the forum, the image is slightly corrupted. I posted a message on their page. If they fix it I will look at it...

Bookworm is no longer referred to as Raspbian. It was renamed to Raspberry Pi OS quite a while ago. As a consequence, the PINN installations are now called Raspios_armXXX. The...

Sorry, I've only just seen this as I didn't get an email notification (better to post in /procount/pinn). Is this still an issue? The usual problem is plugging your HDMI...

I suggest that you add `ssh vncshare forctrigger` to recovery.cmdline and connect it to your LAN with ethernet cable. You'll have to consult your router or use an App like...

PINN can boot from SD card, or USB. An OS must boot from the same drive where PINN is installed. In general, any additional partitions can be installed to the...

> A better fix - the previous version caused an issue with multiple slot SD card readers where the card was not in LUN0 Sorry Tim, my original SD card...

Sorry the upgrade didn't quite work out for you. The new version is quite a bit bigger to accommodate the Pi5 kernel and I struggled to get it to fit...