Could you help me a little bit on my question?

[Sloan-Liu]

Hi Dr. Zhang, Thank you for the shared materials! Recently, I have simulation cases running on Compute Canada, these cases could run well on my laptop. Here is the batch file,

`#!/bin/bash

#SBATCH --account=def-*** #SBATCH --ntasks-per-node=48 #SBATCH --time=12:10:00
#SBATCH --job-name=test1 #SBATCH --output=job-%j.out

module force purge module load openfoam/7

blockMesh setFields decomposePar mpirun -n 48 interFoam -parallel reconstructPar`

The blockMesh, setFields, and decomposePar worked well, can be seen in the .out file. However, the calculation only runs for 1 step, then no more results came out, as shown below:

May I ask have you seen this kind of problem? I tried a lot, but could not solve the problem. Thank you in advance!

Best Sloan Liu

[phresher]

Hi Sloan,

I was on Compute Canada as well, but I think the problem is general. I cannot give any suggestions without more info. You may add me zhangqi1673 on WeChat.

Kind Regards,

Qi