EmonLib

EmonLib copied to clipboard

Does EmonLib work for Raspberry PI too?

1

ommmid

I tried to calibrate the phase shift but look to need a value outside the predefined range of 0-2 at 0 I get powerfactor of 0.96 at 1 I get...

jjtoard

I dont now where the mistake is, with Arduino UNO everything works fine, if I use the Nano Iot the Values are complete wrong. I set the "analogReadResolution(ADC_BITS);"in the setup....

RiggiTraud

Arduino Nano Every NOT Supported

1

Hi guys, we have bought the newest arduino nano every for our IOT projects and to monitoring houses consumptions. However, we have seen that your library does not yet support...

GabriCattazz01

Emonlib+Esp32+ADS1115 outputting inconsistant data

9

I did get it to work, by rewriting the emonlib library, but it was crontoversly to say at least. But it works perfectly, it still is measuring the current. The...

korishan

Making Emonlib non-blocking

1

Hello, I've had a brief look at the code and I'm wondering if it's possible to make the CalcVI function asynchronous? i.e. be able to constantly calculate the voltage and...

TurboNerd95

Arduino Wifi rev 2 compatibility

3

It doesnt seem like this library works with the arduino uno wifi rev 2 due to the change of the analog pin names. I get the following error: ```Arduino: 1.8.13...

1omarsaid

I have different Loads and when I calibrate my voltage and current code for one setting, it does not work the same for another setting. Ex - I have calibrated...

ChaitanyaYeole02

mobinbyn

Wrong (lower) current values with SCT-013-030?

3

I have an SCT-013-030 (30A, 1V peak signal, internal burden resistor 62 Ohm) connected to a UNO as "regular" schema (voltage divider with 2x10k from +5V to GND, and a...

dotto59