openflow-tutorial
openflow-tutorial copied to clipboard
mininet
Openflow Tutorial on Mininet
I was going through the OpenFlow tutorial today and had difficulties with the section [_Start Controller and view Startup messages in Wireshark_](https://github.com/mininet/openflow-tutorial/wiki/Learn-Development-Tools#start-controller-and-view-startup-messages-in-wireshark). The command `controller` in `$sudo controller ptcp:6633` could...
Hi. This might be a very basic issue, but I have been trying to configure a host-only network interface without success. I added host-only interface to VM and I can...
Is it possible to dynamically adjust the rate at which packets are sent in python?
So I am following the instructions here https://github.com/mininet/openflow-tutorial/wiki/Learn-Development-Tools I am at the part where I need to start WireShark. I ran the command to start it, it does start, but...
i created 3-tiers architecture used in datacenters in **Mininet** using learning switches without any controller, i added hosts at the access layer and tried to ping 2 hosts ( i...
Greetings, I've installed Mininet-VM. I was advised to add an additional host-only network adapter so I can use log in to the VM image. But this is what I get...
Hi, I followed up Openflow-tutorial and installed Ubuntu-desktop with using this prompts: $ sudo apt-get update $ sudo apt-get install xinit ubuntu-desktop virtualbox-guest-dkms (restart vm - I am using virtualbox)...
which version of open vswitch supports open flow 1.3 and 1.4 version
In chapter [Router Exercise](https://github.com/mininet/openflow-tutorial/wiki/Router-Exercise), it seems that the image that shows the basic topology is trasparent something that causes the following problem when GitHub's dark theme is enabled: 
