jeremytodd1

Results 22 comments of jeremytodd1

Flow Rate Pass 1 & 2 should set "Top shell thickness" and "Bottom shell thickness" to 0 to avoid a solid print

Whenever I use Orca's flow rate calibration tests I scale up the z just a tad so there is at least a couple layers of infill in it. This way,...

Flow Rate Pass 1 & 2 should set "Top shell thickness" and "Bottom shell thickness" to 0 to avoid a solid print

> > Whenever I use Orca's flow rate calibration tests I scale up the z just a tad so there is at least a couple layers of infill in it....