George

Resistors it is. Starting now. Using pin headers as example as this seems to have a good config setup system! On Fri, 13 Oct 2017 at 02:55, easyw wrote: >...

I have been, have a script that makes a reasonable-looking version of most of them now. Slightly simplified relative to the original WRLs but I'm not sure whether that might...

Brown it is, and I’ll put the fillet in. :) > On 21 Oct 2017, at 11:24, Frank Severinsen wrote: > > Awesome :) ill be digging into the SMD...

Fine with any models I’ve made being licensed however is necessary.

Keen on the idea of sharing input between footprints and 3d; a 1:1 alignment is the policy at the moment anyway.

+1 for this!

Clever workaround! I ended up creating a new component that does this; has since been merged. See https://github.com/esphome/esphome/pull/3124

+1 for this, would love to convert my two esphome converted sensibos into internal controllers that interface directly with the unit!

+1 for this...

Hi Martin, The firmware for the device is created using 'esphome': https://esphome.io/ Think of it like tasmota - but it has the key difference of building firmware specific for each...