Deleted user

gate driver is using 15v and the vbat sensing only have 1 resistor in the voltage divider it also will not work

despite there is a coil on the pcb this board is designed for linear 15v regulator it would not be hard to install

mcu labeled as 64k always have 128k you can use just not tested i have confirmed the pin i trace is correct but im ot sure if itll work ive...

101 resistor to bottom right is connected to i2c/hardware serial

for some reason this board must be flashed with serial(core reset fail) using swd in bootloader also does not work luckily it is very easy to flash with serial on...

the board is drawing 100ma in idle at 3.3v and 150ma at 24v i think it is faulty i have acidently connect 5v to the mcu before but it seems...

turns out the gyroscope/imu is shorted after removing it(which is def easier said then done without a hot air gun) it draw 30ma and the stlink does not want to...

ok kinda got it to the hall detect but motor just vibrate allot and cannot detect hall sensor


I am making changes too fast it's not worth my time making video now Or I should say not worth my time making a high quality video now Foc support...