Deleted user

 This is the wheel from the hoverboard and as you can see it's all plastic and there is only 3 parallel copper wire for the winding so it's probably...

i am hardware guy thats why im here looking for code from more intelegent people like you can you please compile firmware for me i am afraid to use keil...

Some additional closeup picture increase you needed it as the full picture is very blurry     

updated schematic 

I hope I didn't got too many pin wrong so it'll work in few try Where do I connect the stlink to flash it Can keil work with fake st...

I will try to flash when I'm home Plastic wheel indeed is very light weight but I'm not sure how much power it can handle is it really worth it...

i have tested board with original fw no led is found i have alr taken the hoverboard apart and its not going back together so look elsewhere for the picture...

i have just tested the remote dummy firmware when i push the button the turn signal lighting continuely when i release the button the power latch works and the board...

i swapped yellow and green the pinout of rotating led is 15v,orange(master only),green,red why not use pa2 pa3 as serial as its ment to do i can solder the pin...

I have connected to the uart and when I connect USB to serial and baud 19200 it send something that is not humanly readable I tried to connect to esp(which...