geiger

geiger copied to clipboard

Alert всегда в состоянии ON

1

Для проверки alert_threshold выставил в значение 12, Alert сработал и перешел из состояния OFF в ON, после я alert_threshold поправил на значение 20, но Alert теперь всегда в состоянии ON....

dream700

Different Zigbee module

7

Hi! Is it possible to use different Zigbee module. Instead of E18-MS1PA1-PCB to use E18-MS1PA2-PCB. I know of differences between two of them but looks like every module sold now...

BeardedTinker

Hi, On the schematic and BOM, the trim potentiometer is labelled as 200. Is this 200ohm or 200kilohm? Many thanks!

danieledwardgeorgehitchcock

Capacitor C8 & C9

1

Can you give a link for the capacitor c8 and c9, from what I can see these should be 10uf ceramic smd capacitors ?? volt. https://www.aliexpress.com/item/1005003300558193.html?spm=a2g0o.store_pc_allProduct.8148356.5.4c601f46WlTg4b Is this correct ?...

DirkTas67

It would be great to have basic instructions for IDE setup and build

2

Hello, it's a very nice project! Could you please add some instructions for setting this up in IDE, building and uploading? Thanks in advance.

vladkozlov69

after update to 1.0.8 do not want do pair with zzh

1

like in topic. 1.0.7 works properly

Bartekn86

What to do in case device resets after some period of time? Receives new "nwkAddr" everytime. 2 CTC-5 tubes

Actpohomoc

Buzzer

2

Hello! Could you add buzzer support? (Signal - BUZ. Contact 10 (P1.5) Е18МS)

frendhomeio

On this firmware version and the latest version of the gateway firmware, no longer need to configure the parameters? Only available in the state tab: linkquality radiation_dose_per_hour radioactive_events_per_minute trSeqNum

JerryLutor

After months of work without problems, I needed to repair the device because of some mash reorganisation. I removed the device form the network and tried to set it to...

Neshco