Daniel Nilsson

Interesting, I suppose that cable could work yes. It has the correct connectors at least. I would assume it has the same pin layout as Bafang gear since the 860C/EKD01...

Yes, PL=PWR=VIN is 48V line to power on controller by displays command so that sounds good!

Yeah, basically that guide works, there is no special configuration when flashing TSDZ2.

The firmware is pretty much guaranteed too not work on anything other than the supported motors. You risk destroying your controller by doing that

Thank you! Looks nice on a first check, I want to get this merged. But this PR has a lot of commits and merge commits in history. Any chance you...

This looks good, thanks for the PR!

@thompson-shaun I have a similar issue when passing build context (tar.gz archive) via STDIN to a multi node multi platform build. Problem does not occur on a single node emulated...

I will post the exact output when I have access to the system again on Monday but I was using standalone buildx binary v15.1 with kubernetes driver with two nodes:...

@thompson-shaun I upgraded to latest version, issue still exist. buildx version `github.com/docker/buildx v0.16.2 99dea6dacacc3d604788953088560b9880550570` buildx ls ``` NAME/NODE DRIVER/ENDPOINT STATUS BUILDKIT PLATFORMS cicd-buildkitd-march* kubernetes \_ buildkit-amd64 \_ kubernetes:///cicd-buildkitd-march?deployment=buildkit-amd64&kubeconfig= running v0.15.1...

PMSM firmware not reimplemented, separate controller for that and a bit difficult to flash since controller has to be taken out of the aluminum housing and potting from bottom of...