bbs-fw
bbs-fw copied to clipboard
danielnilsson9
TSDZ2B with EKD01 Display
Hi, I've bought a TSDZ2B kit with EKD01 Display and I was wondering if I can use an OFW with this Display. As I understand, EKD01 is a Bafang compatible Display, so I was wandering if I can use this or any other OFW whith my kit, and what I need for it. Thank you!
I was just coming to look for the same answer — With a 1T4 8 pin to 5 pin display cable, is that the right cable pinout?
Interesting, I suppose that cable could work yes. It has the correct connectors at least. I would assume it has the same pin layout as Bafang gear since the 860C/EKD01 display exists for both TSDZ2 and bafang motors. I would assume you need different firmware or configuration on the 860C/EKD01 display to use the Bafang display protocol which this firmware uses.
Of course if it is the incorrect pin layout it will probably burn your display and/or controller. Let me know if you order one and test.
I have attached images of pinouts from when I built my cable by replacing the contacts on the original TSDZ2 VLCD5 wiring harness.
Bafang display/throttle pinout is here:
TSDZ2 wiring harness 8pin contact:
Wire colors in original cable (careful, colors could have changed):
Oh fantastic. I'll be looking into this as I have a TSDZ2 with a broken display, and a spare EKD01.
So my cable (archive.ph) checks out with the exception of what's labeled PWR in the photo, and "vin" in the schematic, and orange in the Bafang pinout. I think that's good to go, but the labels don't match (VIN = PL = PWR?)
Yes, PL=PWR=VIN is 48V line to power on controller by displays command so that sounds good!
It's alive! My EKD01 is not working (the display is dead), but I've got another (simple) Bafang display controlling the motor now!
Flashed with stm8flash, stock 1.5.0 release, and it works!
All told still cheaper (and more waterproof) than the TSDZ2 VLCD5. The display ain't fancy but it'll do until I shake out a spare EKD01 or similar. This opens up a lot of options!