Patrik Mayer

@DennisH1978, I've wrote about the speed difference a while ago. https://allgeek.de/2018/01/29/esp8266-neopixel-controller/ (german)

> @ codmpm thx fpr your link, but if i got my success without building an whole new controller, i try this first :-) You're welcome, but that's not what...

Hey... pretty sure I'm using Core 2.3.x... and currently GPIO as this is the "old" design of my board.

Hey @pklarsjo, we do not power the MCU over the 1-wire bus itself, there's always a dedicated 5V line for this. The Problem seems, that the ATMega tries to power...

As I did not get another suggestion we went with the MAX9940. We tried @orgua's idea with the resistor in series but that does not prevent the break down of...

What is the output of the change-node (complete message object)?

I'm not familar with `changeto/3` to change anything on the loxone side. Could you maybe check what is needed to control the loxone module you are using?

Hey @DSew20, we will have a look into this but we currently have time constraints. @codmdu could you maybe give this a look?

@codmdu could have a look into this?

Hey @tbernaerd, could you test this with `0.10.12`? Thanks!