VW_Flash
VW_Flash copied to clipboard
bri3d
DQ381 FRF Full flash
Hello, flashing a calibration file for the dq381 works. but why doesn't flashing a full FRF work? stays at block 3, 100% and then nothing happens anymore. nothing was taken over
These control units have a bug in their reflash process where block erase and validate requests fail and need to be retried indefinitely. I haven’t worked around this bug yet. Best to full flash with ODIS-E or VCP if you need to change versions.
On Tue, Jul 2, 2024 at 12:37 PM Eddy0697 @.***> wrote:
Hello, flashing a calibration file for the dq381 works. but why doesn't flashing a full FRF work? stays at block 3, 100% and then nothing happens anymore. nothing was taken over
— Reply to this email directly, view it on GitHub https://github.com/bri3d/VW_Flash/issues/135, or unsubscribe https://github.com/notifications/unsubscribe-auth/AABTO2LSBEBG4PUP2ODDUXDZKLXPNAVCNFSM6AAAAABKIDB7EKVHI2DSMVQWIX3LMV43ASLTON2WKOZSGM4DMOJQGI4DGMQ . You are receiving this because you are subscribed to this thread.Message ID: @.***>
These control units have a bug in their reflash process where block erase and validate requests fail and need to be retried indefinitely. I haven’t worked around this bug yet. Best to full flash with ODIS-E or VCP if you need to change versions. … On Tue, Jul 2, 2024 at 12:37 PM Eddy0697 @.> wrote: Hello, flashing a calibration file for the dq381 works. but why doesn't flashing a full FRF work? stays at block 3, 100% and then nothing happens anymore. nothing was taken over — Reply to this email directly, view it on GitHub <#135>, or unsubscribe https://github.com/notifications/unsubscribe-auth/AABTO2LSBEBG4PUP2ODDUXDZKLXPNAVCNFSM6AAAAABKIDB7EKVHI2DSMVQWIX3LMV43ASLTON2WKOZSGM4DMOJQGI4DGMQ . You are receiving this because you are subscribed to this thread.Message ID: @.>
Does this apply to the newest (post 2022) DQ381's? Is there any way that clutch pressure and shifting points can be set without actually having to decrypt/crack the TCU?
