ArduinoCore-mbed issues

Support for Pico second serial port

2

Hi! To my dismay I found Serial2 didn't work when I started messing with the Pico. This change adds the pin definition required for Serial 2 to GPIOs 8 &...

o-gent

`analogRead()` does not reset pin properly after previous `pinMode()`

3

BSP: Arduino MBed OS Giga boards v4.0.10 Board: Giga R1 Arduino IDE: 2.2.1 Sample sketch: ```c void setup() { Serial.begin(9600); while (!Serial) { } // Attach A0 to 3.3V through...

dhalbert

Is deep sleep supported on Edge Control ?

7

Hi, I've tried to enable the deep sleep condition on the Edge Control Board, but the results are bad and not different from the normal sleep function: the board consumption...

brinata

Notify when there is data in socket rx buffer

1

This change makes it possible for a user of the MbedClient to get an asynchronous notification when there is data available in the RxBuffer. This eliminates the need for the...

Helienzo

rp2040 core does not use rom floating point functions

7

The rp2040 includes optimized floating point functions in ROM, using linker magic to replace the standard gcc floating point functions when building applications from the pico SDK or Philhower core....

WestfW

enhancement

RP2040

SPI.beginTransaction() doesn't set the new mode.

1

TL:DR, SPI clock level is not adjusted to SPI mode before CS is asserted low. Consider the example program below on Raspberry Pi Pico. It performs alternative SPI transactions using...

zapta

GIGA R1 - SerialX.flush() does not work

2

As I mentioned in the forum post: [SerialX (X=1-4) are unbuffered? surprised ](https://forum.arduino.cc/t/serialx-x-1-4-are-unbuffered-surprised/1178363?u=kurte) The call to SerialX.flush() does not work as I expected, nor does it comply with the documentation....

KurtE