AJ Quick

@rob-luke Any idea on what needs to be reformatted?

You were correct! Should be good to go now!

I have also added a PR #34 which adds support for Port SMTP 465. That port requires the use of the function SMTP_SSL instead of SMTP.

The change @sslupsky made had it working on Kicad 6 for me.

Still works! I just had to make sure my ad blocker was turned off.

I could certainly look at what it would take the make a change. My thought is the software should just check the chipset prior to restricting pins. If it sees...

Perhaps it is more dependent on the module itself rather than which core is used. On the [ESP32-WROOM](https://www.espressif.com/sites/default/files/documentation/esp32-wroom-32e_esp32-wroom-32ue_datasheet_en.pdf) this is stated: >Pins GPIO6 to GPIO11 on the ESP32-D0WD-V3/ESP32-D0WDR2-V3 chip are...

Checking. Apparently the information can be obtained by reading the fuses. >$ESP420 >Chip ID: 30755 >CPU Cores: 2 >CPU Frequency: 240Mhz I'm seeing there might be a function called: ``ESP.getChipModel()``...

Trying to come up with a restricted list based on the datasheets: ### Restricted Pins | Pin (GPIO) | Usage | Chip | |--|--|--| | 6 | Flash / Ram...