Request for Flashforge Dreamer / Dreamer NX printer profiles

[atanisoft]

Is there an existing issue for this feature request?

• [X] I have searched the existing issues

Is your feature request related to a problem?

I've not been able to locate a profile for the FF Dreamer or FF Dreamer NX printers. I'd like to use my FF Dreamer printer with it's dual nozzles via OrcaSlicer.

Which printers will be beneficial to this feature?

All

Describe the solution you'd like

Addition of profiles for Flashforge Dreamer and Dreamer NX printers

Describe alternatives you've considered

No response

Additional context

No response

[shafror]

I second this.

I'm told that my Dremel 3D45 has the same firmware as FF Dreamer NX, and would love to get away from using outdated Cura that works with Dremel.

[a-dam-berger]

I agree. There really isn't a good slicer for Flashforge Dreamer as the Flashprint software is junk compared to all others and I would love to switch to Orcaslicer as I also have a Bambu X1C in the shop

[atanisoft]

I wouldn't say that FlashPrint is junk entirely, it just leaves a lot to be desired.

[snintendog]

Would Third this If i remember right its a minor change from the Dremel G Code and there was an oddity with the dual Nozzle Dreamers in Cura that only the left nozzle works.

[Bretterson]

Fourthing this!

[X4merxb]

I too would like to have these settings for the Flashforge Dreamer. Thank you