RefineryX

> This does work with zha. The way I fixed it is I upgraded the firmware on it. If I remember correctly I plugged my conbee into my windows machine....

This is super helpful, thanks @SiM22! I followed the above and bumped into a few issues. My meter runs at the pulse of 3200. I used this [website](https://www.rapidtables.com/convert/number/decimal-to-hex.html) to convert...

Thanks. Checking the ``divisor`` and it is ``1000``. I tried to update this too ``3200`` and it did not throw an error. However, although it appears that it accept it......

Like this? If so, I get no error on the logs but it does not accept the number. Clicking ``GET ZIGBEE ATTRIBUTE`` shows ``1000`` remains. Checking also back to ``unit_of_measure``...

Greatly appreciate it, thanks so much! Looking forward to get this working.

Just tried that nothing saves, 1000 sticks. Are you able to successfully change the pulse rate on your side? The manufacturer code of 4117 was recommended by someone else. Section...

Thanks for that. So, I went down a rabbit hole with it this morning. First, I updated the firmware on my Conbee II stick to deCONZ_ConBeeII_0x26780700.bin.GCF released May 15th ([here](https://deconz.dresden-elektronik.de/deconz-firmware/?C=M;O=D))....

@javicalle tried this a few times with the manufacture code of ```4117```. It allows me to input but it does not save. **Saving the new value with manufacturer code:** **Getting...

I hope these debug logs help. I changed updated the value from ``1000`` to ``3200`` using manufacture code ``4117`` at 20:52pm and copied all the logs since. Extract from Debug...

@javicalle were these logs okay? Happy to pull others if needed.