JaredC01

This has happened on a few occasions, though I'm not 100% sure of the cause yet. You can adjust the extrusion width and test, and please let me know the...

LDO will have parts available in the near future. I can't give a specific timeline as it's up to their supplier. I'll update with a link when I have one.

The CAD files will be released once the full-release drops. I understand the issue with this for wanting updated skirts, but there are ways around using the CAD to add...

That's an accurate statement, yes. I'll be working on a revised manual for the injection parts to avoid any confusion prior to full release.

Yes, for the carrier against bearing, there should be a shim in both. The manual will need a full once-over prior to release, so that's on the list!

I need more info... have you used G2Z prior to G2ZXL, and if so, did you have issues with G2Z as well? The gears are all the same, the motor...

That's because G2E's manual is up-to-date for the injection molded parts, while the G2SA manual still assumes MJF parts. The injection molded parts do not require being run-in with a...

> I found four mistakes in the G2Z CAD data. > > 1-11x8x0.5mm shim:3 > > not in kit or manual. > > 2-[a] stepper_plate_left x2 and [a] stepper_plate_right x2...

The 0.6A run current for the E in particular is mainly due to heat. The stepper can handle 0.8A, but some people get worried about the temperature of the stepper,...

Hi @husnainali09! This project is not abandoned, but it is currently stale due to my real-life schedule. If you're having issues with unloading, your issue will be with your hotend...